ELABO Insulation Tester for mounting in a Control cubicle

!Important Notice!

Please note that deliveries are only possible within Germany. For international orders, please contact your respective local partner to proceed with your purchase.

ELABO PE-Conductor Tester for mounting in a Control cubicle.

Test voltage 6 / 12V AC
Test current 2 ... 40 A manually adjustable
Measuring ranges: 5 ... 1200 mOhm
The connections (feedthrough terminal) are on the front panel.

The control and parameterization is done via the
built-in Ethernet interface.
Optional are the connections for the new
ELABO remote control (15 - pin D-SUB,
female) and the digital interface (25-
pole D-SUB, female).

The interfaces and the power connection are on
the lower side accessible.
The mains connection is as GST 18 built-in
connector executed.

Inclusive ELABO calibration certificate

TECHNICAL SPECIFICATIONS:

AC power supply: 230V, 50Hz / 60Hz +24 Vdc external (DIO, RC)
Open circuit voltage: 6 / 12V AC
Test current: 2 ... 40A manually adjustable
Output power: max. 480W
Measuring range: 5 ... 1200 mOhm
Monitoring: R_max, I_min and U_max
Adjustable test time: 0.5 s ... 1d adjustable in 0.1s increments
Power-on time: 50%, max. 60 sec.

Display of measured values, deviations,
Accuracy:
Test current:
Display resolution: 2.00A ... 40.00A: 0.1A
Measuring accuracy: ± 1%, ± 20 digits

Test voltage:
Display resolution: 50mV ... 12V: 10mV
Measuring accuracy: ± 10 digits

Resistance:
Display resolution: 5mOhm ... 1,2Ohm: 10mOhm
Measuring accuracy: ± 30 digits

Including ELABO extension module DIO
4 digital inputs and 6 digital outputs

Additional 4 digital inputs:
- Start
- Stop
- Remote
- Reserve

6 digital outputs:
- Faulty test object
- Test running
- Test OK
- Pulse (250ms) to open a pneum. test cover
- System error
- Control ext. discharge relay

Dimensions:
Width = 214 mm (42TE)
Depth = 240 mm
Height = 220 mm

Technical modifications and errors excepted.

Optionally available with calibration.