ELABO Insulation Tester for mounting in a Control cubicle

!Important Notice!

Please note that deliveries are only possible within Germany. For international orders, please contact your respective local partner to proceed with your purchase.

ELABO Insulation Tester for mounting in a Control cubicle.

Test voltage: 50 ... 1200V DC
Measuring range: 100k - 10GOhm
Resistance measuring range: 10kOhm ... 5GOhm
The test current is limitted to
1mA. Therefore further safety precautions
for the operator are not necessary.

The control and parameterization is done via the
built-in Ethernet interface.
Optional are the connections for the new
ELABO remote control (15 - pin D-SUB,
female) and the digital interface (25-
pole D-SUB, female).

The interfaces and the power connection are on
the lower side accessible.
The mains connection is as GST 18 built-in
connector executed.

Inclusive ELABO calibration certificate

TECHNICAL SPECIFICATIONS:

AC power supply: 100V - 240V, 50Hz / 60Hz +24 Vdc external (DIO, RC)
Test voltage: 50V ... 1200V, variable adjustable in 1V increments
Output power: max. 1W
Measuring range: 100kOhm ... 10GOhm
Monitoring: R_min and R_max (contact monitoring) U_set (test voltage)
Adjustable test time: 0.5 s ... 1d adjustable in 0.1s increments
Automatic range selection or fixed
Measuring range after worst-case analysis

Display of measured values, deviations,

Accuracy:

100,0 kOhm … 999,9 kOhm: 100 Ohm
1,000 MOhm … 9,999 MOhm: 1 kOhm
10,00 MOhm … 99,99 MOhm: 10 kOhm
100,0 MOhm … 999,9 MOhm: 100 kOhm
1,000 GOhm … 9,999 MOhm: 1 MOhm
ab 10,00 GOhm: 10 MOhm

Voltage:

100,0 kOhm … 999,9 kOhm: ±0,5% v. MW, ±2 Digit
100,0 MOhm … 999,9 MOhm: ±1,0% v. MW, ±2 Digit
1,000 GOhm … 4,999 GOhm: ±2,0% v. MW, ±2 Digit
5,000 GOhm … 9,999 GOhm: ±3,0% v. MW, ±2 Digit
>10,00 GOhm: ±5,0% v. MW, ±2 Digit

Display resolution: 0,05kV ... 1,2kV: 0,01kV
Measuring accuracy: up to 1,2kV: ± 0.5%, ± 1Digit

Including ELABO extension module DIO
4 digital inputs and 6 digital outputs

Additional 4 digital inputs:
- Start
- Stop
- Remote
- Reserve

6 digital outputs:
- Faulty test object
- Test running
- Test OK
- Pulse (250ms) to open a pneum. test cover
- System error
- Control ext. discharge relay

Dimensions:
Width = 61mm (12TE)
Depth = 235 mm
Height = 220 mm

Technical modifications and errors excepted.

Optionally available with calibration.